|
|
|
 
Please note: Yamaha Fiche is for reference only, prices are in US dollars and not Canadian. 
|
|
|
|
|
|
|
|
|
|
Label Backlight System
|
|
|
|
| |
- Easily installed in Blue Sea System’s circuit breaker panels
- Connects to 12 or 24 Volt sources via two 6” 18 AWG wire leads
Specifications: - Voltage: 12 or 24 Volts DC
- Amperage Draw: 5 Milliamperes per label
Label Backlight System Instruction- The backlight board is mounted between the 2 black bus support blocks on the back of the panel as shown. The 8065 backlight board is easily shortened fo fit all Blue Sea System's backlightable panels with 5 or 3 label positions. For panels with 8 label positions, no shortening of the boards is necessary. For panels with 5 label positions, snap off Section “C” furthest from the wire leads. Loosen the single screw retaining the lower bus block exactly 1 turn. Then loosen the upper screw 2 turns. With the green LED's facing the panel, insert the bottom tab nearest the wire leads into the slot and rotate the lower block back into position. Lightly tighten both bus screws
Note: Limited Quantity
|
|
|
|
|
|
|
|
| | Sikitu is now selling Janitorial and Industrial Cleaning Supplies. We carry a large supply of cleaning chemicals, floor wax, paper products, brooms, mops, dust mops, vacuum cleaners, shop vacs, bounce, dishwashing detergents, liquid dish soap, garbage bins,garbage bags, soap dispensers, hand soap,3M pads in different sizes etc.
If we don't have it, we will try and find it for you.
|
| |
|
|
|
